Question 1

Refer to the exhibit.
The DHCP server and clients are connected to the same switch. What is the next step to complete the DHCP configuration to allow clients on VLAN 1 to receive
addresses from the DHCP server?

Accepted Answer

Correct answer: C

Question 2

What causes a port to be placed in the err-disabled state?

Accepted Answer

Correct answer: B

Question 3

Refer to the exhibit.
An engineer is configuring an EtherChannel using LACP between Switches 1 and 2 Which configuration must be applied so that only Switch 1 sends LACP
initiation packets?

Accepted Answer

Correct answer: C

Question 4

R1 as an NTP server must have:
• NTP authentication enabled
• NTP packets sourced from Interface loopback 0
• NTP stratum 2
• NTP packets only permitted to client IP 209.165 200 225
How should R1 be configured?
A)

From SurePassExam
https://www.surepassexam.com/200-301-exam-dumps.html (903 New Questions)
B)
C)
D)

Accepted Answer

Correct answer: B

Question 5

Which interface mode must be configured to connect the lightweight APs in a centralized architecture?

Accepted Answer

Correct answer: D

Question 6

Which value is the unique identifier that an access point uses to establish and maintain wireless connectivity to wireless network devices?

Accepted Answer

Correct answer: B

Question 7

Refer to the exhibit.
An engineer assumes a configuration task from a peer Router A must establish an OSPF neighbor relationship with neighbor 172 1 1 1 The output displays the
status of the adjacency after 2 hours. What is the next step in the configuration process for the routers to establish an adjacency?

Accepted Answer

Correct answer: B

Question 8

From SurePassExam
https://www.surepassexam.com/200-301-exam-dumps.html (903 New Questions)
- (Topic 3)
A network engineer must configure two new subnets using the address block 10 70 128 0/19 to meet these requirements:
• The first subnet must support 24 hosts
• The second subnet must support 472 hosts
• Both subnets must use the longest subnet mask possible from the address block Which two configurations must be used to configure the new subnets and meet
a
requirement to use the first available address in each subnet for the router interfaces? (Choose two )

Accepted Answer

Correct answer: BD

Question 9

Refer to the exhibit.
A static route must be configured on R14 to forward traffic for the 172 21 34 0/25 network that resides on R86 Which command must be used to fulfill the request?

Accepted Answer

Correct answer: D

Question 10

DRAG DROP - (Topic 3)
Drag and drop the characteristics of networking from the left onto the networking types on the right.

Accepted Answer

From SurePassExam
https://www.surepassexam.com/200-301-exam-dumps.html (903 New Questions)