Question 1

Refer to the exhibit:
This output is included at the end of an output that was provided by a device using NETCONF. What does the code show?

Accepted Answer

Correct answer: C

Question 2

Refer to the exhibit.
Tier 1 ISP A is connected to small Tier 3 ISP B. The EBGP routing protocol is used for route exchange. The networking team at ISP A noticed the flapping of BGP
sessions with ISP B. The team decides to Improve stability on the network by suppressing the subnet for 30 minutes when a session begins to flap. Which action
must the team perform to meet this goal?

Accepted Answer

Correct answer: B

Question 3

Which additional configuration is required for NetFlow to provide traceback information?

Accepted Answer

Correct answer: B

Question 4

Refer to the exhibit.
What does the number 2 mean in the configuration?

From SurePassExam
https://www.surepassexam.com/350-501-exam-dumps.html (370 New Questions)

Accepted Answer

Correct answer: D

Question 5

Exhibit:
A network engineer must update the routing toward the web server with IP address 35.22.13.1. The primary path must be configured via the neighbor router with
ID 1.1.1.1. However, local-preference configuration is not permitted on R1. Which task must the engineer perform on R1 to complete the implementation?

Accepted Answer

Correct answer: C

Question 6

A network operator working for a telecommunication company with an employee Id: 4065 96080 it trying to implement BFD configuration on an existing network of
Cisco devices Which task must the engineer perform to enable BFD on the interfaces?

Accepted Answer

Correct answer: D

Question 7

Which configuration modifies Local Packet Transport Services hardware policies?
A)
B)

From SurePassExam
https://www.surepassexam.com/350-501-exam-dumps.html (370 New Questions)
C)
D)

Accepted Answer

Correct answer: C

Question 8

Refer to the exhibit.
A network engineer must configure an LDP neighborship between two newly installed routers that are located in two different offices. Router 1 is the core router in
the network and it has already established OSPF adjacency with router 2. On router 1 and router 2. interface fa0/0 is configured for BFD. Which additional
configuration must the engineer apply to the two devices to meet the requirement?

Accepted Answer

Correct answer: D

Question 9

Refer to the exhibit.
Router 1 is missing the route for the router 2 loopback 0. What should the engineer change to fix the problem?

Accepted Answer

Correct answer: A

Question 10

Which type of attack is an application attack?

Accepted Answer

Correct answer: C