Question 1

DRAG DROP
Drag and drop the tools from the left onto the corresponding primary functions on the right.

Accepted Answer

In the FLDTEC curriculum, technicians are trained on physical tools essential for support in the field.
These tools and their uses are explained as follows:
Flash Card Reader: Used with removable CompactFlash cards commonly found in older Cisco routers and switches. These cards hold the IOS image or config
files.
USB Thumb Drive: Used for transferring IOS files or configs directly to and from Cisco devices that support USB storage. Convenient for portable backups.
RJ-45 Ethernet Loopback Connector: A diagnostic tool that loops the signal back into the port. Helps verify port functionality by simulating a live Ethernet
connection.
RJ-45 Coupler: Allows two patch cables to be connected, effectively extending the reach of a cable ?? useful in setups where a single cable is not long enough.

Question 2

Why is it important to verify the update status after the initial upgrade process when upgrading firmware on a Cisco UCS C-Series server using the Host
UpgradeUtility?

Accepted Answer

Correct answer: B

Question 3

What does OIR stand for in the context of Cisco ASR component replacement?

Accepted Answer

Correct answer: D

Question 4

Which Layer 2 technology extends to access layer devices, allowing individual switch ports to be assigned for network and traffic management in an enterprise
network?

Accepted Answer

Correct answer: B

Question 5

What is the function of an access layer device?

Accepted Answer

Correct answer: B

Question 6

How must the power to a system with dual power supplies on aCisco Nexus switch be connected?

Accepted Answer

Correct answer: C

Question 7

DRAG DROP
Drag and drop the descriptions from the left onto the corresponding IPv4 addressing modes on the right.

Accepted Answer

This content is aligned with IPv4 Addressing Fundamentals, detailed in the FLDTEC course under
Device Configuration and Verification:
Unicast: A unicast address uniquely identifies a single host on a network. This is the most common address type used for standard communication between two
devices.
Broadcast: Broadcast addresses (e.g., 255.255.255.255 or subnet-specific broadcast) send traffic to all hosts in the network segment. Used for ARP requests and
DHCP discovery.
Multicast: Used to deliver a packet to a group of hosts interested in the data, without flooding the network like a broadcast. Multicast uses addresses from the
range 224.0.0.0 to 239.255.255.255. Loopback: The loopback address (127.0.0.1) is reserved for local testing, ensuring that the TCP/IP stack is working properly
without needing to access the network.

Question 8

A technician must quickly identify multiple Cisco switches in a rack without powering them on. Where should the technician look for serial numbers on the device?

Accepted Answer

Correct answer: C

Question 9

What happens to the switch operation when a supervisor module in a Cisco Nexus switch is replaced by two supervisor modules?

Accepted Answer

Correct answer: B

Question 10

Which two actions ensure a smooth transition to the new hardware when replacing a Cisco UCS C-Series Rack-Mount Server? (Choose two.)

Accepted Answer

Correct answer: BD